Over the weekend, I finally got around to a project I’ve been wanting to do: repurpose a tree round from the tree they cut down in front of our house earlier this spring. Plus, the round was finally dried out enough that I could 1.) move it and 2.) get the bark off in a reasonable amount of time.
The best part was Lucy and Stella (two of my three daughters) were super excited to help out!
Here are the basic steps:
- De-bark the tree round. I used a hammer and pry bar. Most of it came off pretty easy, although there were a few stubborn areas. </p>
Sand it down. I used a combination of fine and medium sandpaper blocks to get the round nice and smooth to the touch. Stella and Lucy were huge helps in sanding this behemoth.
Once you are done sanding, wipe the round down with a wet, lint-free towel to prep it for staining.
Put the legs on. This was actually sort of difficult, as the round was pretty uneven on the bottom. I did end up finding four spots that were equidistant apart and fairly centered on the bottom for support. I used Ikea Capita legs that are adjustable, so we can level the table on any surface.
Stain it. I used a honey maple stain, which ended up darker than I pictured, but looks good nonetheless. Stella and Lucy helped stain the top, as well.
Finish with a polyurethane. I used a fast drying clear satin polyurethane to protect the wood and give it a nice, rustic look:
I did three coats on the sides and six plus on the top, since it soaks in so much. So pleased with how it turned out, but most of all I was glad to make something with my hands and have Lucy and Stella help out. A great experience for all of us!